石油学报 ›› 2017, Vol. 38 ›› Issue (11): 1293-1298.DOI: 10.7623/syxb201711008

• 油田开发 • 上一篇    下一篇

高含水条件下CO2混相驱替实验

吕成远1,2, 王锐1,2, 崔茂蕾1,2, 唐永强1,2, 周霞1,2   

  1. 1. 中国石油化工集团公司海相油气藏开发重点实验室 北京 100083;
    2. 中国石油化工股份有限公司石油勘探开发研究院提高采收率技术研究所 北京 100083
  • 收稿日期:2017-02-23 修回日期:2017-08-08 出版日期:2017-11-25 发布日期:2017-12-08
  • 通讯作者: 吕成远,男,1963年9月生,1986年获华东石油学院学士学位,2002年获中国科学院地质与地球物理研究所博士学位,现为中国石油化工股份有限公司石油勘探开发研究院教授级高级工程师,主要从事提高采收率技术方面的研究工作。Email:lcy.syky@sinopec.com
  • 作者简介:吕成远,男,1963年9月生,1986年获华东石油学院学士学位,2002年获中国科学院地质与地球物理研究所博士学位,现为中国石油化工股份有限公司石油勘探开发研究院教授级高级工程师,主要从事提高采收率技术方面的研究工作。Email:lcy.syky@sinopec.com
  • 基金资助:

    国家重大科技专项(2016ZX05048-003)资助。

Displacement experiment of CO2 miscible flooding under high water condition

Lü Chengyuan1,2, Wang Rui1,2, Cui Maolei1,2, Tang Yongqiang1,2, Zhou Xia1,2   

  1. 1. Sinopec Key Laboratory of Marine Oil & Gas Reservoirs Production, Beijing 100083, China;
    2. Department of Enhanced Oil Recovery, Sinopec Petroleum Exploration and Production Research Institute, Beijing 100083, China
  • Received:2017-02-23 Revised:2017-08-08 Online:2017-11-25 Published:2017-12-08

摘要:

油藏水驱后进行CO2驱已在油田现场取得了成功,但由于油藏的高含水饱和度,导致了CO2与原油间的接触方式发生改变,混相过程也受到一定制约。为研究高含水条件对CO2混相驱的影响,制作了盲端微观可视化模型,进行了水驱前后CO2混相过程微观实验。结合不同含水饱和度条件下的CO2驱替实验,明确了CO2混相驱替特征以及含水饱和度对CO2驱油效率的影响。结果表明,高含水饱和度会对CO2与原油的接触过程产生一定的屏蔽作用,注入的CO2不能直接接触到剩余油,从而导致CO2与原油的混相过程被大大延缓,进而导致高含水条件下CO2驱见效时间被推迟。

关键词: 高含水条件, CO2驱, 动态混相, 盲端模型, 驱替特征

Abstract:

CO2 flooding has been successfully applied on site after water flooding. But due to the existence of high water saturation, the contact mode between CO2 and crude oil has been changed, and the development of miscible process is also restricted. Aiming at the influences of high water condition on CO2 miscible flooding process, the microcosmic visualization models of dead ends were prepared for the microcosmic visualiation experiment of CO2 miscible process before and after water flooding. In combination with CO2 flooding experiment under different water cut conditions, the characteristics of CO2 miscible flooding were clarified as well as the effects of water saturation condition on CO2 displacement efficiency. The results show that high water saturation will generate a certain shielding effect in the process of CO2 contacting with crude oil, and the injected CO2 is unable to contact residual oil directly. So the CO2-crude oil miscible process is greatly postponed, thus causing the delayed responding time of CO2 flooding under high water condition.

Key words: high water condition, CO2 flooding, dynamic misciblity, dead-end model, displacement characteristics

中图分类号: